13
Step 1
Place the Treatment Array on the area to be treated. Keep it
applied to the skin to ensure maximum transmission of light
into the tissues. The Treatment Array may be held rmly in
place either with the straps provided or manually.
Step 2
Press the power button to turn the system on or o. You’ll
hear an audible double beep and the power button will turn
blue when it is turned on.
Step 3
Press the circle on the Controller Unit that corresponds to the
area of the body to be treated (e.g., face, knee, etc.). When
selected, the circle will turn blue.
Step 4
The Treatment Stage of the BioFlex 120 automatically defaults
to stage 1 (recommended for at least the rst ve treatments).
Press the button again for stage 2 or 3, if needed.
Step 5
Press the Start/Pause button to begin the treatment. There will
be an audible beep and the countdown timer will begin. The
length of each treatment varies depending on the area select-
ed. For optimal results, run the treatment to completion (until
the timer ends).
If you need to stop or pause your treatment for any reason,
press the Start/Pause button. Pressing the Start/Pause button
again will resume your treatment.
Step 6
Press the Stop button once at any time to pause the treat-
ment. Press Stop twice to cancel the treatment.
To Next Page
Loading...