What to do if my Meditech Medical Equipment displays an E02 error?
If your Meditech Medical Equipment displays an E02 error, it means the Treatment Array is too hot (exceeding 48°C), possibly due to being covered or used for too long. The system will automatically shut off until it cools down. Allow the Treatment Array to cool for at least 15 minutes before reusing it.
How to fix no power or blank display on Meditech BioFlex 120?
If your Meditech Medical Equipment shows no power or the display is blank, first, plug the power supply into a working wall outlet and ensure the cable is securely connected to the Controller Unit. You should hear a beep once the power is connected. Then, press the Power button to turn the unit on.
What to do if Meditech Medical Equipment displays an E01 error?
If your Meditech Medical Equipment beeps and displays an E01 error, unplug and then re-plug the Treatment Array. After that, press the start/pause button on the Controller Unit to continue the treatment. If the problem continues, it may require professional attention.
What to do if Meditech BioFlex 120 displays an E03 error?
If your Meditech Medical Equipment beeps and displays an E03 error, ensure the cable is properly connected to the Controller. If the problem persists, it may require professional attention.
How to troubleshoot damaged Meditech BioFlex 120?
If your Meditech Medical Equipment has been dropped or damaged, check all power connections to ensure all cables are secure and properly connected. If the unit still does not power on after checking the connections, press the Power button on the Controller Unit. If it remains unresponsive, it may require professional attention.
What does it mean when Meditech BioFlex 120 displays E04-E12 errors?
If your Meditech Medical Equipment beeps and displays an E04, E05, E06, E07, E08, E09, E10, E11 or E12 error, record the specific error code and it may require professional attention.
What to do if Meditech BioFlex 120 Medical Equipment gets wet?
If your Meditech Medical Equipment has become wet due to spills or excessive humidity, immediately unplug all system components from the electrical outlet. It may require professional attention.
Categorized lists of medical conditions the device is intended to treat.
Lists conditions and situations where the device should not be used.
Details the components and functions of the main controller unit.
Details the components and functions of the treatment array.
Describes potential reactions and side effects during treatment.
Illustrates how to position the treatment array for the face.
Illustrates how to position the treatment array for the shoulder.
Illustrates how to position the treatment array for the elbow.
Illustrates how to position the treatment array for the wrist.
Illustrates how to position the treatment array for the hand.
General| Category | Medical Equipment |
|---|---|
| Model | BioFlex 120 |
| Manufacturer | Meditech |
| Operating Mode | Continuous or Pulsed |
| Power Requirements | 100-240V AC, 50/60 Hz |
| Power Output | 120mW |
| Cooling System | Air Cooled |
| Display | LCD |
| Parameters | Treatment time, frequency, power level |
| Power Supply | AC adapter |
To Next Page