15
Stage
There are 3 pre-programmed stages for each of the 12 treatments
available on the Controller Unit. Each stage is meant for dierent stages of
the healing process. Stage 1 provides the best results for most cases and
should be used for as long as possible. Using stage 2 is only advisable if
there is no improvement after 5-10 full treatments. Skipping from stage 1
to stage 2 may result in less pain relief. Stage 3 should only be used if stage
2 no longer provides any pain relief after 5-10 treatments.
Frequency
Acutely painful areas may be treated daily until the pain and other
symptoms diminish.
Possible Reactions and Side Eects
During the course of treatment, the dermis may become erythematous,
secondary to physiological eects. This condition is not harmful and will
disappear following completion of treatment. Use the glasses provided
throughout the course of treatment, however they are not essential.
End of Treatment
Treatments end automatically unless you press the Stop button prior to
that occurrence. Clean the Treatment Array after each use (see page 28).
As your symptoms diminish you may reduce the frequency of treatments
and in order to avoid recurrence, treat once or twice per week. For chronic
pain, treat as required for maintenance purposes.
Should your pain not diminish after utilizing the three Stages provided for
each area, it is appropriate to consult a physician.
To Next Page
Loading...