Medlab medizinische Diagnosegeräte GmbH EG01010 User Manual
Version 1.06
6 7
Technical Data (Specifications)
Mechanical data: 88 mm x 53 mm
see page 4 for board drawing
4 layer PCB, thickness 1.5 mm
Maximum height: 12 mm
With respiration option: 25 mm
Attachment: four M2.5 screws in the corners of the PCB
Weight: 32 g
Operating voltage: 5 Volt, ± 10 %, 45 mA
Power consumption: 225 mW while measuring
Input: Defibrillation protected
Patient Isolation: CF, 4000 Volts RMS
Amplification: Three levels, user selectable
Data transmission: Three frequencies, user selectable
Filtering: Integrated 50 Hz or 60 Hz notch filter
Amplifier frequency range: 0.05 to 70 Hz
Pulse detection: 30 .. 247 bpm ± 1%, ± 1 Digit, 8 beat average
Respiration detection: 5 .. 99 rpm ±3%, ± 1 Digit, 8 samples average (option)
Output: Asynchronous serial output with CMOS levels (0 ... 5 V)
Hardware pulse trigger output, CMOS levels (0 ... 5 V)
Both outputs fully isolated from patient
Protocol: Standard bidirectional serial protocol, see description
on following pages
Connector: Connectors compatible to Medlab EG05000 five channel OEM board
Optional connectors for Medlab 00731 respiration board
To Next Page
Loading...