12 MEDLINE | MDS4003
Setting Date, Time and Measurement Unit
It is important to set the clock before using your blood pressure monitor,
so that a time stamp can be assigned to each record that is stored in the
memory. (year: 2014 - 2054, Time format: 24H/12H)
1. When the batteries are first installed, the device
will automatically prompt you to set the [YEAR]
first.
If the batteries have already been installed, when
the monitor is off, press and hold the “MEM&SET”
button for about 3 seconds to enter into setting
mode. The blinking numeral represents [YEAR].
2. Press the “MEM” button to change the [YEAR].
Each press will increase the numeral by one in a
cycling manner.
3. When you get the right year, press “START/STOP”
button to confirm your selection and it will turn
to the next step.
To Next Page
Loading...
Need help?
General
