Meec tools 000903 - USE; Fuel; Filling; Start the clearing saw

EN
53
Harness
1. Place the harness over the shoulders and
close the clasp.
2. Adjust the harness so that it sits
comfortable.
FIG. 10
3. Adjust the height of the machine with the
help of the harness straps and the harness
attachment on the machine.
4. Release the harness by pulling the locking
piece forwards.
FIG. 11
5. The harness has a safety device, which
can be quickly released in an emergency
situation. Pull the red tab on the clasp
rmly to immediately release the machine
from the harness.
FIG. 12
USE
Fuel
WARNING!
• Risk of personal injury.
• Fuel is highly ammable and can be
explosive in certain circumstances.
• Turn o the engine and allow it to cool
before relling with fuel.
• Follow all the safety instructions for
handling the fuel.
• Always refuel before use.
NOTE:
• The recommended mixing ration is 40:1
– 40 parts fuel to 1 part oil.
• Mix the fuel with good quality 2-stroke
oil, intended for air-cooled 2-stroke
engines.
Filling
1. Shake the container with the fuel mixture.
2. Place the clearing saw on a level, stable
surface with the fuel cap facing upwards.
3. Clean the ller cap and the area around the
opening to avoid contamination entering
the tank.
4. Carefully open the ller cap so any
overpressure is relieved. Use a funnel and
do not overll.
5. Carefully ll up with fuel. Avoid spilling.
6. Replace the ller cap and tighten rmly.
7. Wipe o spilled fuel and allow any fuel
residue to evaporate before starting the
engine.
NOTE:
• Never use oil intended for 4-stroke
engines or water-cooled 2-stroke engines.
This type of oil can contaminate the spark
plug and exhaust port or cause the engine
to seize.
• Oil mixed fuel that has stood for more
than one month can contaminate the
carburettor resulting in the engine not
running correctly. Store leftover fuel dark
and cool in an air-tight container.
• Switch o the engine before lling up
with fuel. Never ll up with fuel when the
engine is running or hot. Fire hazard!
Start the clearing saw
1. Turn the power switch on the throttle to the
I position.
2. Move the choke lever to position
.
FIG. 13
3. Press the primer bulb at least 10 times
before starting the engine for the rst time.
FIG. 14
4. To start the engine, pull the starter cord
slowly until it catches (10–15 cm) and then