Meec tools 014137 - Page 33

EN
33
USE
ACCESSORIES
Materials and accessories for cleaning
and polishing, including personal safety
equipment, are sold separately in Jula’s
department stores and at www.jula.com.
BATTERY
Charging the battery
The battery must be charged before it can
be used with a tool. After charging for the
rst time, use the tool until the battery is
completely at. Repeat this charging and
discharging cycle 4 to 5 times.
• If the LEDs on the charger do not go on
when charging:
– check that the charger’s mains
adapter is properly plugged into
the power point and that the
charger is switched on
– check that the battery is correctly
inserted in the charger
1. Place the battery charger on a level and
stable surface. Plug the charger into a
230 V power point.
2. Connect the battery to the charger so
that it clicks in place. The red LED on the
charger goes on when correct contact is
made.
FIG. 2
3. When the battery is fully charged, after
about one hour, the red LED goes o and
only the green LED stays on.
4. Pull out the plug from the power point
and release the battery from the charger.
FIG. 3
standardised test method, can be used to
compare dierent tools with each other and
for a preliminary assessment of exposure.
The measurement values have been determined
in accordance withEN 62841-1, EN62841-2-4.
WARNING!
The actual vibration and noise level when
using tools may dier from the specied
maximum value, depending on how the
tool is used and the material. It is therefore
necessary to determine which safety
precautions are required to protect the user,
based on an estimate of exposure in actual
operating conditions (taking into account all
stages of the work cycle, e.g. the time when
the tool is switched o and when it is idling,
in addition to the start-up time).
DESCRIPTION
Battery powered polishing machine with
oscillating movement pattern and a highly
variable speed (2100–5000 rpm).
The powerful motor is brushless and comes
with overload protection. Thanks to the
comfortable grip surfaces, you can work both
ergonomically and safely.
1. Power switch
2. Display
3. Button to increase speed
4. Button to reduce speed
5. Battery lock
6. Charging status light
7. Battery
FIG. 1
MEEC MULTI-SERIES
The product is a part of the Meec Multi-series –
a series of power tools and garden equipment
that uses the same battery and charger.