Meec tools 014137 - Technical Data

EN
32
SYMBOLS
Read the instructions.
For outdoor use only.
Approved in accordance with
the relevant directives.
Recycle discarded product
in accordance with local
regulations.
TECHNICAL DATA
Polishing machine
Voltage 18 V DC
Speed 2100 – 5000 rpm
Disc diameter 125 mm
Oscillating Yes
Stroke rate 15 mm
Sound pressure level, LpA 75 dB(A), K=3 dB
Sound power level, LwA 86 dB(A), K=3 dB
Vibration level, A
h
4.56 m/s², K=1.5 m/s²
Battery charger
Input voltage 230 V
~
50 Hz
Power output 40W
Output voltage 14.4–18 VDC
Output current 2.4 A
Safety class II
Protection rating IPX0
Battery type Lithium
Cells (number and voltage) 5 x 3.6 VDC
Always wear ear protection.
The declared values for vibration and noise,
which have been measured according to a
REDUCTION OF NOISE AND
VIBRATIONS
• Plan the work so that exposure to heavy
vibrations is spread over a longer period.
• To reduce noise and vibrations when in
use, limit the time the tool is in use, and
use low-power/vibration mode and
suitable safety equipment.
• Take the following precautions to
minimise the risks of exposure to
vibrations and/or noise:
– Only use the tool in accordance with
these instructions.
– Check that the tool is in good
condition.
– Use accessories in good condition,
and which are suitable for the
purpose.
– Keep a rm grip on the handles/
grips.
– Maintain and lubricate the tool in
accordance with these instructions.
DUST
• Dust produced during the work can be
harmful to health, carcinogenic,
ammable or explosive. Use a dust lter
mask and suitable equipment for dust
extraction/collection.
• The dust from some alloys can catch re,
or explode. Mixtures of materials increase
the risk – keep the work area clean.
WARNING!
Fire risk. Dust in dust bags, vacuum cleaners
or lters can self-ignite or be ignited by
sparks, hot workpieces or other sources of
heat, especially if it comes into contact with
polyurethane, solvent-based paint and other
chemicals. Make sure that the tool and/or
workpiece do not overheat. Always empty
the dust container before pausing the work.