5.2 Oiling and Lubricant
The operator should be responsible for the proper lubrication of
the machine. The grade and quality of lubricant are given in the
lubrication chart below :
Oil Lubrication chart
Lubricating Point Lubricant Quantity Oiling Frequency
1.
Blade Tension
Device
DAPHNE FLUID 32T Few Twice a year
2.
Drive Wheel
Bearing
Grease Few Thrice a year
3. Guide Slides Shell Tonna 33 Few Oil daily
4.
Transmission
Gear Box
DAPHNE GEAR LUBE 320 Few Twice a year
5.
Cutting Fluid
Tank
Cutting Oil Mixture
(KH ULTRA COOL EX-2)
82 liter Daily
6.
Hydraulic Oil
Tank
DAPHNE FLUID 32T 44 liter Twice a year
Belt Size
Belt Name Belt Size Quantity
7 Motor Belt
50HZ use 3V475 & 60HZ use 3V450
Inverter use 3V450
1
8 Wire Brush Belt M42 1
5 - 2
To Next Page
Loading...