Mega H-330A - Page 30

異常編號 異常名稱
Remedy
排除方法
20
21
22
鋸帶啟動按鈕卡死異常
Starting blade button jammed
1.Eliminate breakdown
2.Press Blade-ascending button
1.排除故障原因
2.按鋸帶上升按鈕
23
鋸帶下降按鈕卡死異常
Descending blade button jammed
1.Eliminate breakdown
2.Press Blade-ascending button
1.排除故障原因
2.按鋸帶上升按鈕
24
送料架前進按鈕卡死異常
Feed-forward button jammed
1.Eliminate breakdown
2.Press Blade-ascending button
1.排除故障原因
2.按鋸帶上升按鈕
25
送料架後退按鈕卡死異常
Feed –forward button jammed
1.Eliminate breakdown
2.Press Blade-ascending button
1.排除故障原因
2.按鋸帶上升按鈕
26
前夾鉗-開 按鈕卡死異常
Front vise opening button jammed
1.Eliminate breakdown
2.Press Blade-ascending button
1.排除故障原因
2.按鋸帶上升按鈕
27
28
29
自動閒置過久(5 分鐘)
Auto to leave unused overlong (5
minutes)
30
自動切削計數到達
Auto cutting piece counting over
1.Press Blade-ascending button
2.Press the key, CLEAR
1.按鋸帶上升按鈕
2.按面板 CLEAR 鍵
31
鋸帶上升按鈕卡死異常
Blade-descending button jammed
1.Eliminate breakdown
2.Press Blade-descending button
1.排除故障原因
2.按鋸帶下降按鈕
32
自動切削計數到達未歸零
Auto cutting piece counting over: don’t
zero
1.Press Blade-ascending button
2.Press the key, CLEAR
1.按鋸帶上升按鈕
2.按面板 CLEAR 鍵
33
鋸輪蓋,皮帶輪蓋未蓋
Wheel-cover and pulley-cover unclosed
1.Eliminate breakdown
2.Press Blade-ascending button
1.排除故障原因
2.按鋸帶上升按鈕
34
鋸帶未夾緊異常
No clamping-tight blade
35
36
鋸帶切削時,前夾鉗未夾緊
No clamping-tight front vise while
cutting
1.Eliminate breakdown
2.Press Blade-ascending button
1.排除故障原因
2.按鋸帶上升按鈕
37
38
鋸帶切削時,以偏移出至設定
while cutting, blade-departure from
setting
1.Eliminate breakdown
2.Press Blade-ascending button
1.排除故障原因
2.按鋸帶上升按鈕
6-4