Megamaster Blaze400 - Page 15

4. Triangle Bracket Assembly
a) Loosen but do not remove four screws on Bottom
Panel (B), two screws on Cart Leg Rear Left (G) and
two screws on Cart Leg Rear Right (I). Align the holes of
the Triangle brackets with the screws in the Bottom
Panel (B) and Cart Leg Rear Left (G) and Cart Leg Rear
Fig. 6
B
G
I
Q
R
Right (I) to connect Triangle Bracket Left (Q) and
Triangle Bracket Right (R) to Cart Leg Rear Left (G) and
Cart Leg Rear Right (I). As shown in Fig. 6.
b) Tighten the screws.
Note: The flat portion of the triangle brackets should
face the rear of the grill.
5. Wheel Assembly
a) Place the wheel (X) on the Axle attached to Cart Leg
Front Right (H) and Cart Leg Rear Right (I), place 1pc
Flat Washer (H7) to the wheel then place and tighten
1Nt(H3) thAl
Ah iFi7
Fig. 7
I
2xH3
2xH7
1
pc
N
u
t
s
(H3)
on
th
e
A
x
l
e.
A
s s
h
ow
i
n
Fi
g.
7
.
b) Repeat step 5a to attached the other wheel.
c) Attached the Wheel Caps (W) on both Wheels as shown
in Fig.7
H
W
6. Cylinder Support Bracket Assembly
Mount the Cylinder Support Bracket (S) onto the Bottom
Panel (B) using 4pcs Truss Head Screws (H2). As show
in Fig. 8.
Fig. 8
H
X
4xH2
15
B
S