Megamaster Blaze400 - Lighting Instruction

Grill Lighting Instructions continued
FLAME CHARACTERISTICS
Check for proper burner flame characteristics.
Burner flames should be blue and stable with no yellow
tips, excessive noise, or lifting. If any of these conditions
exist call our customer service line If the flame is yellow
Visually check the burner flames prior to each
use, The flames should look like this picture, if
they do not, refer to the burner maintenance part
of this manual.
exist
call
our
customer
service
line
.
If
the
flame
is
yellow
,
this is a indication of insufficient air. If the flame is noisy
and tends to lift away from the burner, this is a indication
of excessive oxygen.
Each burner is adjusted prior to shipment;
however, variations in the local gas supply
may make minor adjustments necessary.
Lighting Instructions
Note: Remove all packaging, including straps, before using the grill
1. Open lid during lighting.
2. Make sure all the knobs are in the “OFF” position,
and then turn the Liquid Propane Cylinder valve
“ON” by slowly turning counterclockwise.
3. Push and turn Main Burner control knob to
IGNITE/HIGH, at the same time, press and hold
electronic ignition button to light the burner.
1
2
3
27
4. Once the burner is lit, release the electronic ignition
button and knob.
5. If ignition does not occur in 5 seconds, turn the knob
to OFF, wait 5 minutes and repeat the lighting
procedure or light by match.
3
4