7
Take the main sheet line and hook and feed them through the hole in
the main boom. Then insert the sheet hook into one of the small holes
in the boom and lay it fl at. Next slide back the O-ring to lock the hook
into place.
Now repeat this procedure for the jib sail by taking the jib sheet line and hook
and feeding them through the hole in the jib boom. Insert the sheet hook into
one of the small holes in the jib boom and lay it fl at. Then slide back the
O-ring to lock the hook into place.
It is very important to make sure your sheet line hooks are in the correct posi-
tions. To check this, fi rst install the batteries in the transmitter and switch it on
and then install the batteries in your Nirvana and switch it on (see
page 8 for
instructions). When the left stick on the transmitter is down (in the back posi-
tion), the booms should look like the drawing above. You may have to try the
hooks in different holes to fi nd the correct position. Once you fi nd the correct
hole, you may wish to mark it with a dot of white model paint or nail polish, so
you won’t have to remember for next time.
Adjusting the Sails
To Next Page
Loading...
