4
Assembling Your Nirvana
The Keel
Slide the keel through the slot on the bottom of the hull. Make sure
the rounded side is facing the bow (front) of the boat.
Once fully inserted, turn
the locking lever 90 degrees
to secure the keel into place.
You should now place
your boat upright in
the stand.
The Rudder
Locate the rudder tube at the stern
(back) of the boat. Insert the rudder shaft into
the rudder tube as shown, so that the fl at side
of the rudder is facing the bow of the boat.
Slide the rudder collar onto the rudder shaft,
is aligned with the fl at section of the shaft. Now tighten the collar into place
using a Philips head
screwdriver.
Assembling the Nirvana
To Next Page
Loading...
