8
to always use fresh alkaline batteries, especially in the transmitter. To
be safe, you should insert fresh batteries into the boat after a few hours
of use. We recommend Megatech’s
®
Golden Power series, designed for
R/C products.
The Radio Control
Open the hatch on the rear of the radio
control. Install 8 AA alkaline batteries. Be
sure the batteries are properly arranged or
your controller will not function. Reattach
the battery hatch.
Installing the Batteries
Installing Batteries
The Boat
The hatch cover and hatch seal protect
the batteries and servo. Gently pull up on
the lip at the rear of the hatch cover to remove it
and then lift off the hatch seal. Next, carefully
pull out the battery holder and insert 4 AA
alkaline batteries. Take care to insert the batteries in the correct direction.
Carefully reinsert the battery holder into the boat, put the hatch seal on,
making sure that it seals snugly and then snap the hatch cover back into place.
Make sure the tiller arm and antenna cord come through the slot at the rear of
the hatch cover.
ALWAYS SWITCH ON THE TRANSMITTER FIRST… THEN
SWITCH ON THE BOAT.
Failure to do so may result in damage to the Nirvana’s servos. Always turn on
the transmitter and then it’s safe to switch on the boat.
Now it’s time to go sailing!
To Next Page
Loading...
