Setting up your boombox
Connecting the AC cord
1 Make sure that your local AC power source matches the voltage shown on the
plate located on the bottom of the boombox.
2 Insert the small connector at the end of the AC cord into the AC IN jack on the
back of your boombox.
3 Plug the AC cord into a wall power outlet.
Installing the batteries
1 Turn your boombox over, then open and remove the door to the battery
compartment.
NOTES:
Unplug the AC cord when not in use.
The batteries are automatically bypassed when the AC cord is used.
- Power Electrical Specs: 100-240V ~ 50/60 Hz
www.megatekelec.com
Portable CD Player with Bluetooth CB-M25BT
2 Insert four (4) UM-2 ("C") size alkaline batteries into the battery compartment.
Make sure that you match the + and – symbols on the batteries with the +
and – symbols in the battery compartment.
3 Reinstall and close the battery compartment door and return your boombox
to the upright position.
NOTES:
CAUTIONS:
Follow these precautions when using batteries in this device:
• Use only the size and type of batteries specied.
• Make sure that you follow the correct polarity as indicated in the battery
compartment when installing batteries. Reversed batteries may cause
damage to your boombox.
• Do not mix dierent types of batteries together or semi-used batteries
with fre
sh ones.
• If your boombox is not to be used for a long period of time, remove the
batteries to prevent damage or injury from possible battery leakage.
• Do not try to recharge batteries not intended to be recharged, because they
can overheat and rupture. (Follow battery manufacturer’s directions.)
• Do not throw batteries into a re. Dispose of used batteries as hazardous
waste.
06
• Alkaline batteries are recommended, for they support longer playtime than
carbon zinc batteries.
• The AC cord must be disconnected from both the AC IN jack on the back of
your boombox and the AC power outlet in order for your boombox to
operate on battery power.
To Next Page
