Aux in mode
Connect the 3.5mm end of the audio cable (supplied)
to the headphone (or auxiliary out) socket of your
secondary device. Connect the other two Micro-USB
ends to the Aux in sockets on the back of both your
Bluetooth speakers. This will switch your bluetooth
speaker to Aux in mode.
1.
TF (Micro-SD) card mode
Insert a TF (Micro-SD) card into the card slot on the back
of either of your Bluetooth speakers, with its label side
facing up. This will switch the inserted speaker to TF
card mode.
1.
Press the Play button on your external device to start
playback through the Bluetooth speakers.
2.
To gain optimal volume levels, adjust the volume level
on both the secondary device and on the Bluetooth
speakers.
3.
Note: After you have finished listening to your external
device you must unplug the audio cable from the Aux
in sockets, to be able to use them as Bluetooth speakers
again.
Note: TF (Micro-SD) cards can only be inserted in one
direction. If the card does not easily slide and “clip” into
place, remove, turn it around, and re-insert into the slot.
10
To Next Page
Loading...