ACCESSORIES
Supplied Part Number
Test lead set
User Guide 6172-048
Optional
Synthetic Test & carry case 6420-030
Test lead set (2 leads, 2 clips) 6220-434
Test lead set with fused prods. 6111-287
(Not recommended for continuity tests).
Publications
‘A Stitch in Time’ AVTM21-P8B
REPAIR AND WARRANTY
The instrument circuit contains static sensitive devices, and care must be taken
in handling the printed circuit board. If the protection of an instrument has been
impaired it should not be used, and be sent for repair by suitably trained and
qualified personnel. The protection is likely to be impaired if, for example, the
instrument shows visible damage, fails to perform the intended measurements,
has been subjected to prolonged storage under unfavourable conditions, or
has been exposed to severe transport stresses.
New Instruments are Guaranteed for 3 Year from the Date of Purchase
by the User.
N o t e : Any unauthorized prior repair or adjustment will automatically invalidate
the Wa r r a n t y.
Instrument Repair and Spare Parts
For service requirements for M E G G E R
®
Instruments contact :-
AVO INTERNATIONAL
or AVO INTERNATIONAL
Archcliffe Road Valley Forge Corporate Center
Dover 2621 Van Buren Avenue
Kent, CT17 9EN Norristown, PA 19403
England U.S.A.
Tel: +44 (0) 1304 502243 Tel: +1 (610) 676-8500
Fax: +44 (0) 1304 207342 Fax: +1 (610) 643-8625
or an approved repair company.
Approved Repair Companies
Anumber of independent instrument repair companies have been approved for
repair work on most
MEGGER
®
instruments, using genuine
MEGGER
®
spare parts. Consult the Appointed Distributor / Agent regarding spare parts,
repair facilities and advice on the best course of action to take.
Returning an Instrument for Repair
If returning an instrument to the manufacturer for repair, it should be sent freight
pre-paid to the appropriate address. Acopy of the Invoice and of the packing
note should be sent simultaneously by airmail to expedite clearance through
Customs. A repair estimate showing freight return and other charges will be
submitted to the sender, if required, before work on the instrument
c o m m e n c e s .
To Next Page
Loading...
