SECTION VI
1. Trouble Shooting Note
If
the Control Panel Display is too dim to read when the test set is initially turned on,
perform the following:
A. Press the right hand menu softkeyonce.
B.
Press the left hand menu softkey until the display is appropriately illuminated.
C.
Press the right hand menu softkey (underneath the word exit) twice to return to
the metering display.
2.SERVICE DATA
The test set utilizes straightforward circuits and components which require little or no
service except for routine cleaning, tightening
of
connections, etc. The test set should
be serviced
in
a clean atmosphere away from energized electrical circuits. The
following maintenance is recommended:
34
To Next Page
Loading...
Need help?
General
