eXMP-SynqNet Quick Start Guide: Linux
5. After saving the valid network interface parameters, reboot the eXMP using the ‘reboot’
command, or use the ‘shutdown’ command and then cycle power. After the eXMP completes the
Linux boot process, the eXMP should be accessible from another computer on the local area
network. The eXMP runs an anonymous FTP server, and a telnet server.
To connect to the eXMP FTP server from a Windows PC, type the following from a Command
Prompt (using the new IP address for the eXMP):
ftp 192.168.1.74
Use ‘anonymous’ or ‘ftp’ as the login name; the password you choose does not matter.
Full read/write, get/put access is allowed with the eXMP in every directory. Here is a screenshot
of an ftp session:
Copyright © 2003, Motion Engineering, Inc 11 of 11 DCR 704; rev. A
To Next Page
Loading...
General