eXMP-SynqNet Quick Start Guide: Linux
Using the eXMP-SynqNet Motion Controller
By default, the standard Linux XMP device driver (‘/mei/Release/meixmp.o’) is loaded during
startup. This is an MPI version-independent file.
To execute any XMP utilities or applications, load the executable file to the eXMP via ftp, and
execute them from a console or telnet shell.
NOTE: As with any UNIX based system, you will need to set the attributes of any file you ftp
to the eXMP-SynqNet. This can be done using the chmod command. Please consult your
UNIX documentation for more information on using this command.
Congratulations! You have successfully configured the eXMP-SynqNet for console mode
using Linux. The eXMP-SynqNet is now ready for testing and development.
Copyright © 2003, Motion Engineering, Inc 13 of 13 DCR 704; rev. A
To Previous Page
Loading...