Operating instructions Glass-, utensil- and dishwasher
M-iClean U
9763258 15 / 72
Design and construction subject to change without prior notice!
4.7 Fundamental safety and accident prevention regulations
Note
The following safety instructions aim to protect operating personnel as well as other
third parties and the dishwashing machine itself.
Please take note of the information in these instructions and the signs on the dish-
However, safety can only be guaranteed during operation if all necessary measures
are taken.
The operator of the machine has an obligation of care to ensure that these
measures are planned for and also to check that they are correctly implemented.
The operator must ensure in particular that:
• the dishwashing machine is only used in accordance with its intended purpose.
In the event of the machine being used or operated contrary to this, damage or
risks may arise.
• in order to guarantee functionality and safety, only original spare parts supplied
by the manufacturer must be used.
• the safety of the dishwashing machine is not impaired by the subsequent instal-
lation of a dosage facility.
• only appropriately qualified and authorised personnel operate, maintain and
repair the machine.
• no one sits or stands on the open door.
• staff are regularly trained in all questions relating to occupational safety and
environmental protection and are familiar with the operating instructions and, in
particular, the safety information contained therein.
• the dishwashing machine is only operated in perfect, functional condition, all
protection devices and cover panels are installed
• the safety and switching equipment are regularly tested to ensure they are
functioning correctly.
• dishwashing machines which are accessible from the rear may only be oper-
ated with rear panel cladding.
• the required personal protective equipment is made available to and worn by
maintenance and repair personnel.
• a functional test on all dishwashing machine safety systems is carried out at
every regular maintenance.
• none of the safety and warning notices affixed to the dishwashing machine it-
self are removed and all are legible.
• regular checks on supply parts are carried out. If required, more detailed infor-
mation can be found in the relevant operating instructions.
• after installation, commissioning and handing over of the machine to the cus-
tomer/operator, no modifications may be made (e.g. to electrical components or
to the machine's location)
• equipment for optimising energy consumption must not be used to lower the
required operating temperatures, as set out in the standards DIN 10510, 10511
and 10512. If equipment for optimising energy consumption is nevertheless in-
stalled, MEIKO does not accept any responsibility for a possible reduction to
the quality of the wash and to hygiene.
To Next Page
Loading...
Need help?
General
