To Next Page
G
Gregory CarneyAug 7, 2025
How to reset factory settings parameter list on Meiko Dishwasher?
- SScott BlackAug 7, 2025
To reset the Meiko Dishwasher parameters to the factory settings, switch the power supply on and off within 5 minutes.
How to reset factory settings parameter list on Meiko Dishwasher?
To reset the Meiko Dishwasher parameters to the factory settings, switch the power supply on and off within 5 minutes.
What to do when Meiko UPster U 500S Dishwasher shows maintenance required?
When the set operating hours or batch number has been reached on your Meiko Dishwasher, inform the service department and perform maintenance. You can also reset the maintenance counter.
What to do if Meiko Dishwasher says incorrect password / no authorization?
If the Meiko Dishwasher displays 'Incorrect password / no authorization,' try entering the code again.
What to do if Meiko UPster U 500S regeneration is necessary?
The user must start the regeneration of the Meiko Dishwasher. Make sure to empty the tank and add salt.
What to do if the door of Meiko UPster U 500S is not closed?
If the door of your Meiko Dishwasher is not closed, check the S1 connection and change the microswitch. Also, check the microswitch adjustment and consider replacing a defective I/O circuit board.
Why is the emergency program active on my Meiko UPster U 500S?
If the emergency program is active on your Meiko Dishwasher, and washing is restricted, check the system for boiler or tank heating issues and fresh water supply problems.
General| Brand | Meiko |
|---|---|
| Model | UPster U 500S |
| Category | Dishwasher |
| Language | English |
Details the operator's obligations to ensure safe machine operation and maintenance.
Lists fundamental safety rules regarding machine use, electrical hazards, and personal protection.
Steps for checking the delivery completeness and reporting any damages.
Instructions on how to perform an emergency shutdown of the machine.
Key checks and procedures to be followed during the initial commissioning of the machine.
Description and function of the machine's control panel and its keys.
How the machine displays information codes and basic troubleshooting guidance.
Lists error codes, their descriptions, and potential causes for troubleshooting.
Safety precautions to observe during routine operation and maintenance tasks.
Note indicating maintenance should only be performed by authorized personnel.
