If you have any questions, contact technical support at:
Tel: 1-888-MEKRA 4U / Fax: (803) 337 5265
E mail: quality@lang-mekra.com
www.lang-mekra.com
These Products May Be The Subject of Pending U.S. Patent Applications
or May Be Covered By One or More U.S. Patents.
Revised 07/2013
Copyright © 2001 – 2013 For the most recent version of this manual, visit www.lang-mekra.com
T.1.1 Bracket Does Not Fold Back
T.1.2 Bracket Folds Back Too Easily or Vibrates
Brackets are equipped with a fold-away feature, sometimes
referred to as a break-away system. The mirrors will fold back
either manually, or spontaneously upon impact. This feature
helps to minimize damage to the mirror system and the door.
The brackets have rotating attachments that allow the fold away
(break-away) function. The upper holder is designed to give the
bracket stability. However, the upper fastener kit may sometimes
require adjustment. See G.2 to service the upper fastener.
Do not attempt to disassemble the lower holder / break-
away assembly. This assembly is spring-loaded, and
serious injury could occur if improperly serviced.
If the upper fastener kit is too loose, it will have to be tightened. If the
upper fastener kit has been over-torqued and flattened the Belleville
washers, the entire fastener kit must be replaced. See G.2 to service the
upper fastener.
Make sure the attachments to the door are secure.
Ensure the lower pivot is in the correct detent position.
To Next Page
Loading...