If you have any questions, contact technical support at:
Tel: 1-888-MEKRA 4U / Fax: (803) 337 5265
E mail: quality@lang-mekra.com
www.lang-mekra.com
These Products May Be The Subject of Pending U.S. Patent Applications
or May Be Covered By One or More U.S. Patents.
Revised 07/2013
Copyright © 2001 – 2013 For the most recent version of this manual, visit www.lang-mekra.com
(G.5.1) Removing Mirror Glass – Carrier Plate Style
If you have glass-and-bezel style mirror heads, use the procedure on G.5.3.
Your Lang-Mekra mirror system is equipped with a durable mirror
plate. The mirror glass is reinforced with anti-shattering adhesive to
minimize splintering in the event of breakage. We strongly
recommend the prompt replacement of damaged mirror plates.
For a heated mirror, be careful not to damage the wiring or the heater
connections when changing the mirror plate, especially when
detaching heater wires from the mirror plate.
To Remove the Mirror Plate
1) Use a small flat-head screwdriver to push in the locking tabs
through the access slits along the mirror housing. DO NOT use
the screwdriver to pry the mirror plate!
2) Start by pushing in the tab at the top of the mirror, then
continue around the mirror while pulling firmly on the mirror
plate.
3) Pull the mirror plate away from the housing. If the mirror is
heated, detach the heater wires from the back of the plate. Do not
cut the wires.
Slits to access
locking tabs
To Next Page
Loading...