If you have any questions, contact technical support at:
Tel: 1-888-MEKRA 4U / Fax: (803) 337 5265
E mail: quality@lang-mekra.com
www.lang-mekra.com
These Products May Be The Subject of Pending U.S. Patent Applications
or May Be Covered By One or More U.S. Patents.
Revised 07/2013
Copyright © 2001 – 2013 For the most recent version of this manual, visit www.lang-mekra.com
(G.5.2) Installing Mirror Glass – Carrier Plate Style
To Install Mirror Plate
1) If mirror is heated, attach wire terminals to the back of the new mirror plate.
2) Align locking clips on mirror plate with mirror housing. Make sure all the clips are inside the housing
before pushing on the mirror plate! This will keep from damaging the locking clips. Failure to install the
mirror plate correctly could result in vibration, or loss of mirror plate.
3) Press mirror plate into housing firmly, ensuring all clips lock into place.
1. ACCESS HOLES
ON CARRIER
PLATE MUST BE
OUTBOUND
2. ARROWS
DEPICT ACCESS
HOLES BEING
OUTBOUND
3. IGNORE 1 & 2, IF
CARRIER PLATE
HAS ACCESS
HOLES ON BOTH
SIDES.
For Safety
Wear protective Gloves
Wear Safety Glasses
To Next Page
Loading...