Melitta epour - Rinsing After Descaling; Cleaning and Care; Cleaning Procedures; Signal Sound Settings

11
•Asubsequent,briefpress(<1 sec.) of the BREW
button starts the descaling process.
•Onceabouthalfoftheliquidhasrunthroughthe
appliance, stop the process by pressing the BREW
button again briefly (<1 sec.).
•Waitfor10 minutes to ensure that the remaining
descaling fluid removes as much limescale from the
appliance as possible.
•NextreactivatetheappliancebypressingtheBREW
button longer (>1 sec.) and then briefly (<1 sec.). Allow
the remaining fluid to run through the appliance.
•Ifyouhearasignalsound,switchtheapplianceoby
pressing the BREW button longer (>1 sec.).
•Emptythejug.
5.2 Rinsing process after descaling
•Theappliancemustberinsedafterdescalingtoremove
any remaining descaling agent.
•Firstrinseoutthewatertankunderrunningwater.
Then fill the water tank up to the 8-cup mark and put
it back into the appliance.
•Activatetheappliance,startit,asinanormalbrewing
process, and allow all of the water to flow through the
appliance.
•Ifyouhearasignalsound,switchtheapplianceoby
pressing the BREW button longer (>1 sec.).
•Iftheappliancewascompletelydescaledduringthe
descaling process, the CALC lamp will no longer be
illuminated during the rinsing process. If this is still
the case, the limescale in the appliance was so far
advanced that one descaling process was not sucient
to completely descale the heater. In this case, repeat
the descaling and rinsing process one more time.
•Emptytheglassjug.
•Thenrinseouttheglassjugwithwater.
6. Cleaning and care
•Switchotheappliancebeforecleaninganddisconnect
the mains plug.
•Allowtheappliancetocooldowncompletelybefore
cleaning it.
•Cleanthepartsthatcomeintocontactwithcoee
(jug, filter holder etc.) after each use.
•Youcancleanthehousingwithasoft,moistcloth.
•Theglassjugwithlid,thelterholderandthewater
tank lid are dishwasher-safe.
•Whencold,thekeep-warmplatecanbecleanedwith
a soft, moist cloth.
•Donotuseaggressiveorabrasivecleaningagents.
7. Switching off the signal sounds
All signal sounds can be deactivated if necessary.
The appliance needs to have been switched o to do
this. Pressing the BREW and CONTROL buttons at
the same time longer (>1 sec.) deactivates the signal
sounds. Proceed in the same way to switch them on
again. You will hear a brief signal sound upon activation
and upon deactivation
8. Disposal information
•Appliancesmarkedwiththissymbol are subject
to the European Directive for WEEE (Waste Electrical
and Electronic Equipment).
•Electricalappliancesdonotbelongindomesticwaste.
•Disposeoftheapplianceinanenvironmentallyfriendly
way via suitable collection systems.
•Thepackagingmaterialsarerawmaterialsandrecyclable.
Please return them to the raw materials cycle.
G B