What to do if PSU Status LED is red on Mellanox Technologies Spectrum SN2010 Switch?
If the PSU Status LED on your Mellanox Technologies Switch is red, it could indicate a possible PSU issue. First, check or replace the power cable. If that doesn't resolve the problem, you may need to replace the PSU, which is possible in SN2700, SN2740, and SN2410 models.
What to do if Fan Status LED is red on Mellanox Technologies Switch?
If the Fan Status LED is red on your Mellanox Technologies Switch, there may be a fan issue. Check that the fan is fully inserted and that nothing is blocking the airflow. If the issue persists, consider replacing the fan FRU, which is possible in SN2700, SN2740, and SN2410 models.
Why is the System Status LED red on Mellanox Technologies Switch?
A red System Status LED on a Mellanox Technologies Switch indicates a critical system fault, such as a CPU error or bad firmware, or over temperature. Check the environmental conditions, especially the room temperature, to address this issue.
Why is the System Status LED blinking for more than 5 minutes on Mellanox Technologies Spectrum SN2010?
If the System Status LED on your Mellanox Technologies Switch is blinking for more than 5 minutes, it indicates that the Mellanox Onyx (MLNX-OS) software did not boot properly and only the firmware is running. Connect to the system via the console port and check the software status.
General| Manufacturer | Mellanox Technologies |
|---|---|
| Model | SN2010 |
| Product Series | Spectrum |
| Latency | 300ns |
| Form Factor | 1U |
| Port Speed | 10/25/40/50/100 GbE |
| Power Consumption | 150 W |
| Operating Temperature | 0°C to 40°C |
| Storage Temperature | -40°C to 70°C |
| Humidity | 5% to 95% non-condensing |
To Next Page
