STEP 1
- 1. Fill in the water tank with decaling and water
till MAX mark.
- 2. Select any lter to put into the porta-lter.
Position the porta-lter to the unit.
- 3. Place a container right under the brewing
outlet and the steam tube & nozzle .
- 4. Rotate the knob to Coffee position, press
the steam button for 5 seconds. The unit will
start the descaling of coffee brewing system
for 5 minutes. During the descaling the lights
of (E) buttons will ash once one by one. When
the cycle is nished, the (E) buttons will ash
simultaneously.
- 5. Rotate the knob back to steam position to
start descaling of steam system.
- During the descaling, the button lights of sin-
gle cup, double cup and steam will ash once
one by one. The cycle will takes 5 min and
when it nishes, lights of single cup button and
double cup button will ash one by one, and
steam button light will be on. This means the
descaling completes.
STEP 2
- 1. Pour out the decaling mixture from the water
tank. Add fresh water into the water tank to
max mark, and put water tank back to the unit.
- 2. Rotate the knob (D) back to steam position,
press the steam button to start the steam sys-
tem cleaning. The button lights of single cup,
double cup and steam will ash twice one by
one. The cycle will take 1 min. When it nishes,
the button lights of single cup, double cup and
steam ash simultaneously.
- 3. Rotate the knob (D) to coffee function to
start again the cleaning of coffee brewing
system. The button lights of single cup, double
cup and steam will ash twice one by one The
cycle will take 1 min. When it nishes, the unit
will enter pre-heating mode.
ANOMALIES AND REPAIR
- Take the appliance to an authorised technical
support service if problems arise. Do not try to
dismantle or repair without assistance, as this
may be dangerous.
- If the connection to the mains has been
damaged, it must be replaced and you should
proceed as you would in the case of damage.
- If you detect any anomalies, refer to the follow-
ing table:
To Next Page
Loading...
