Mellerware Mmmm! - Troubleshooting

EN
Problem
The appliance does not
work.
The coee is not hot
enough.
The rst cup of coee is
poor quality.
Internal drip tray is lled
with a lot of water.
Coee is delivered too
slowly or a drop at a time.
Lack of bean indicator (B)
ashes but there is still a
lot of coee bean inside
the container (6).
You can’t putt he coee
grounds container and
the machine does not
work (keyboard with
icons o)
The touch buttons are not
sensitive.
The water tank is removed
/ the water level is very low
in the water tank but icon
(A) have no alert.
Coee has no cream.
The appliance takes too
long time to warm up.
No response in several
trials of pressing on
function key on the panel.
The appliance is not
connected to the mains.
The cups have not been
preheated. The brewing
unit is too cold.
The rst run of grinder does
not pour sucient quantity
coee power into the
brewing unit.
Coee powder too ne
which block the water to
come out.
Coee powder too ne
which block the water to
come out.
Internal coee powder
outlet is blocked.
You have removed the
grounds container (3) at half
cycle and now you can’t
enter it.
Not pressing the touch
button from the front
direction of the appliance.
The area near the water
tank connector is wet.
Coee bean is not fresh.
Excessive scale has built up.
Appliance is under
an electromagnetic
interference Dirt over the
panel.
Plug in and press the
switch. Check the cable
and the plug.
Rinse the appliance
at least 3 times before
making the coee.
Throw the coee away.
The other coees will
always be of good quality.
Adjust the coee neness
to bigger dot during
grinder operation.
Adjust the coee neness
to bigger dot during
grinder operation.
To follow the steps of
section (CLEANING
COFFEE POWDER
OUTLET).
Place the coee grounds
container (3) without the
internal drip tray (2) so the
machina detects (3) and
allows the interrupted
cycle to continue. Then
you can put the whole set
(2) + (3).
Press the lower bottom
part of the icon of the
touch button from the
front direction of the
appliance.
Wipe the water around
the water tank connector.
Change or using
appropriate brand of
coee bean.
Descale the appliance.
Unplug the appliance.
Restart after few minutes.
Clean the panel with the
cloth provided.
Cause Solution
TROUBLESHOOTING