To Next PageTo Next PageWhat to do if Member's Mark 720-0830G only heats to 200-300 degrees?
The regulator might have a safety feature that reduces gas flow if it detects a leak. This can activate even without an actual leak. To reset it, turn off all burners and close the LP tank valve. Disconnect the regulator from the LP tank, wait one minute, and then reconnect it. Slowly open the LP tank valve fully. Light all burners and check the temperature.
How to fix Member's Mark Grill that will not light immediately?
If your Member's Mark Grill won't light immediately, ensure you have a spark while lighting the burner. Check the wire connection to the electrode assembly. Clean the wire and/or electrode with rubbing alcohol and a clean swab, then wipe with a clean cloth. Also, check if other burners are working; if so, inspect the gas orifice on the malfunctioning burner for any obstructions.
Why does my Member's Mark Grill take a long time to preheat?
Normal preheating to 500-600 degrees takes about 10-15 minutes. Cold weather and wind may increase preheat time. Volcanic rock or briquettes can also increase the preheat time and maximum temperature.
Why are the burner flames not light blue on my Member's Mark Grill?
If the burner flames on your Member's Mark Grill are not light blue, burner adjustment may be required. The grill may also be in a windy location. Too much or not enough air for the flame. Elevation is the principal cause, however cold weather can affect the mixture.
General| Brand | Member's Mark |
|---|---|
| Model | 720-0830G |
| Category | Grill |
| Type | Gas Grill |
| Fuel Type | Propane |
| Number of Burners | 4 |
| Material | Stainless Steel |
| Ignition Type | Electronic |
| Wheels | Yes |
| Side Shelves | Yes |
| Main Burner BTUs | 48000 |
| Side Burner BTUs | 12, 000 BTUs |
| BTU | 60000 |
Actions to take if a gas leak is detected.
Important warnings about grill usage and storage.
Cautionary advice on preventing flashback fires.
Details on LP gas cylinder specifications and connections.
Detailed steps for connecting the gas supply.
Method for checking gas connections for leaks.
Instructions for igniting the main burners.
Instructions for igniting the searing side burner.
Critical warning about professional installation for NG conversion.
Step-by-step guide for converting main burners.
Step-by-step guide for converting the searing side burner.
