Member's Mark 720-0839

Questions and Answers

A
agatesAug 6, 2025
Why does my Member's Mark 720-0839 only heat to 200-300 degrees?
- T
  Tiffany SmithAug 7, 2025
  The regulator might have a safety feature limiting gas flow due to a potential leak. First, check the fuel hose for any bends or kinks. Ensure the grill area, burner, and orifices are free from dust, spiders, and insects. To reset the safety, turn off all burners, close the LP tank valve, disconnect the regulator, wait one minute, reconnect, slowly open the LP tank valve fully, then light all burners and check the temperature.
M
michaelgonzalezAug 11, 2025
How to fix Member's Mark 720-0839 that will not light immediately?
- M
  Michael HughesAug 11, 2025
  If your grill won't light immediately, ensure you have a spark while lighting the burner. If there's no spark, check the wire connection to the electrode assembly. Clean the wire(s) and/or electrode with rubbing alcohol and a clean swab, then wipe with a clean cloth. Also, check if other burners operate; if they do, inspect the gas orifice on the malfunctioning burner for any obstructions.
C
Cynthia LopezAug 17, 2025
What to do if my Member's Mark 720-0839 takes a long time to preheat?
- A
  Alicia WatersAug 17, 2025
  Cold weather and wind can increase preheat time. A normal preheat to 500-600 degrees should take about 10-15 minutes. Volcanic rock or briquettes can also increase preheat time and maximum temperature.
L
louiswalkerAug 22, 2025
Why are the burner flames not light blue on my Member's Mark Grill?
- C
  Courtney ChristianAug 22, 2025
  The burner flames might not be light blue due to too much or too little air for the flame. This can be caused by elevation or cold weather affecting the mixture. Burner adjustment may be required, or the grill could be in a windy location.
R
richardgarciaAug 27, 2025
Why does the regulator make noise on my Member's Mark Grill?
- Z
  Zoe WadeAug 27, 2025
  The noise from the regulator may be due to a plugged vent hose or a faulty regulator. Check that the vent hole on the regulator is not obstructed. If it is, clear the hole, close the gas control valves, wait ten minutes, and restart. Check your flames for proper performance. If the flames are still not correct, the regulator should be replaced.
H
Hunter MahoneyAug 31, 2025
What to do if the full-size cover does not fit my Member's Mark 720-0839 Grill?
- K
  Katelyn ClarkAug 31, 2025
  The cover might be incorrect for your grill or it may be a tight fit. First, ensure the cover is the correct length by measuring it left to right and comparing it to the grill's measurement. Also, compare the location and size of the hood portion of the cover to your grill. Try spreading the cover and allowing it to relax, preferably in warm sunlight or a warm room. If your grill has a side shelf, bunch the cover like a sock and put it on from left to right.