Memmert BE 600 - MAINTENANCE; General Information; Cleaning; Readjusting the Door

MAINTENANCE
General
information
Memmert appliances require minimal servicing. İt is
recommended, that the moving parts on the doors (hinges and
door lock) should be lubricated with a thin silicone grease once a
year (with continuous use 4 times a year).
In case of a malfunction which makes the opening of the unit ©
necessary this work has to be performed by a gualified
service engineer.
A tightly closing door is an essential requirement on ovens. MEMMERT-ovens
ensure perfectly tight closing of the door through a seal on the oven casing. The
door seal presses accurately against the casing seal. in continuous operation the -
flexible seal material may acquire a permanent set. For proper ciosing of the door it
may be necessary to adjust the hinge or the locking plate.
Readjusting the door
After releasing the screw No.12
(ATTENTION! Screw No. 12 is
securéd with glue. Loosen jerky
with inner hexagon key wrench 2
mm) the door can be adjusted by
turning the eccentric 13 in the
direction of the arrow (using a
screwdriver). Tighten screw No.
12 again.
In addition the upper part No.14
of the door hinge can be moved
slightly in the direction of the
arrow after releasing the 2 screws
at the top or bottom of the door.
The locking plate can also be
readjusted in the direction of the
arrow after releasing the screw
No.15.
Ensure that the cover is again
screwed down'tightly.
UE/BE 200-800/ULE 400-800
14
fig. g
Cleaning
By regular cleaning of the easy to clean interior, residues
are avoided which at continuous influence can impair the
outfit and function of the oven.
The unit can be cleaned with commercial stainless steel cleaning agent. Please
note that objects liable to rust must not be placed into the interior. Rust sediments
lead to contamination of the interior or external casing.
If rust stains caused by contamination occur on the interior surface, the affected
areas must be cleaned and polished immediately. |
UE/BE 200 - 800/ULE 400-800
15