Pairing Bluetooth & Playing Audio
After initial pairing to a Bluetooth device, the headphones
will stay paired unless unpaired manually by the user, or
erased due to a reset of the device. If your device should
become unpaired or you nd it is unable to connect, repeat
these steps.
1. Power ON the headphones. The headphones
default to Bluetooth Mode and are ready to pair
automatically. When pairing, remain within 3 feet of
the Bluetooth device.
2. Using the controls on your Bluetooth device, select
MAHN40 in the Bluetooth Settings to pair. If need
be, refer to the user’s manual for your specic
device for more information.
3. When successfully paired, a voice will announce,
“Bluetooth is connected.” Your Bluetooth device
will now be heard through the headphones.
4. Use the controls on the connected Bluetooth
device to select and play audio. Use the
headphone controls or the connected Bluetooth
device to play, pause, skip and adjust the volume
level. Note: To pair to a different Bluetooth device,
quickly press Power/Play/Pair button twice to
manually enter into pairing mode.
Aux In
Aux In mode will function even if the headphones are not
powered on. To conserve battery power, the headphones
will automatically power off when using Aux In.
Requires a 3.5mm audio cable (included).
1. Connect a 3.5mm audio cable to the Aux In on the
headphones and the audio output on an audio
device.
2. Use the controls on the connected device to select
and play audio.
Active Noise Cancellation
The Active Noise Canceling feature will electronically mute
background noise. It can be used with the Bluetooth mode
to enhance the quality of any music or audio that is playing
through the headphones.
1. To activate noise cancelling, Slide the ANC switch
to the ON position.
2. To deactivate noise cancelling, Slide the ANC
switch to the OFF position.
Previously Connected Devices
• The headphones can remember multiple Bluetooth
devices and will always try to re-connect to the last
device used.
• To re-connect to a different device, turn off Bluetooth
on unwanted devices, then access the Bluetooth
settings menu on the device you wish to use and
select MAHN40.
Warranty
For Warranty Information and the most up-to-date version
of this User’s Guide, go to:
www.memorex.com
FCC Warnings
WARNING: Changes or modications to this unit not expressly approved by the
party responsible for compliance could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment o and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Additional Warnings
• WARNING: To prevent re or shock hazards, do not expose this unit to rain
or moisture.
• WARNING : Where the mains plug or appliance coupler is used as the
disconnect device, such disconnect device shall remain readily operable.
• Lithium batteries, like all rechargeable batteries, are recyclable and should be
recycled or disposed of according to state and local guidelines. They should
never be disposed of in normal household waste, and they should never be
incinerated, as they might explode. Contact your local government for disposal
or recycling practices in your area.
• This product meets and complies with all Federal regulations.
• To avoid hearing damage, make sure that the volume on your music player
is turned down before connecting your headphones. After placing headphones
in/on your ears, gradually turn up the volume until you reach a comfortable
listening level.
WARNING : This product can expose you to chemicals
including lead, which is known to the State of California to
cause cancer and birth defects or other reproductive harm.
For more information go to www.P65Warnings.ca.gov.
This product meets and complies with required Federal
product guidelines.
Customer Support
• Website: www.memorex.com
• Customer Service: 1-888-999-4215
• Email Support: prodinfo@dpiinc.com
• Email Parts: partsinfo@dpiinc.com
Copyright © 2021 Digital Products International (DPI, Inc.)
All other trademarks appearing herein are the property
of their respective owners. Specications are subject to
change without notice.
To Previous Page
Loading...
Need help?
General
