Page 11
NOTE: Cold weather may affect the performance of the
jump starter’s lithium battery. If you hear only a click and the
engine does not turn over, try the following:
With the jump starter connected to the car battery and the
green LED illuminated on the smart cable, turn on all lights
and electrical accessories for one minute. This draws cur-
rent from the jump starter and warms the battery. Now try
to crank the engine. If it does not turn over, repeat the pro-
cedure. Extremely cold weather may require two or three
battery warmings before the engine will start.
NOTE: If no activity is detected, the smart cable will auto-
matically shut off after 120 seconds, and the red and green
LEDs will be solid. To reset, disconnect the clamps from the
vehicle battery, and then reconnect.
IMPORTANT: DO NOT attempt to jump start your vehicle
more than three consecutive times. If the vehicle will not
start after three attempts, consult a service technician.
8.
After the engine starts, unplug the battery clamps from the
jump starter socket and then disconnect the black clamp (-)
and the red clamp (+), in that order. Slide the ON/OFF switch
to the OFF position.
9.
Recharge the unit as soon as possible after each use.
CHARGING A MOBILE DEVICE, USING THE USB PORTS
The 260-9515 includes two USB ports. One provides up to 2.4A
at 5V DC; the other is Quick Charge 3.0, which provides up to 5V
at 3A, 9V at 2A or 12V at 1.5A.
1.
Consult your mobile device manufacturer for proper charging
power specifications. Connect a mobile device cable to the
appropriate USB port.
2.
Slide the ON/OFF switch to the ON position. Charging should
begin automatically. The display will show which port is in
use.
3.
Charging time will vary, based on the mobile device’s battery
size and the charging port used.
4.
NOTE: Most devices will charge with either USB port, but may
charge at a slower rate.
5.
When finished using the USB port, disconnect the charging
cable from your mobile device and then disconnect the
charging cable from the unit. Slide the ON/OFF switch to the
OFF position.
6.
Recharge the unit as soon as possible after each use.
7.
NOTE: If no USB device is connected, power to the USB ports
will automatically shut off after 30 seconds.
To Next Page
Loading...