Page 12
USING THE LED LIGHT
1.
Slide the ON/OFF switch to the ON position.
2.
Hold down the display button for 3 seconds.
3.
Once the LED light is on, press and release the display but-
ton to cycle through the following modes:
• Steady glow
• Flash for an SOS signal
• Flash in strobe mode
4.
When finished using the LED light, press and hold the display
button until the light turns off.
5.
Slide the ON/OFF switch to the OFF position.
6.
Recharge the unit as soon as possible after each use.
10. MAINTENANCE INSTRUCTIONS
1.
After use and before performing maintenance, unplug and
disconnect the unit.
2.
Use a dry cloth to wipe all battery corrosion and other dirt or oil
from the battery clamps, cords, and the outer case.
3.
Do not open the unit, as there are no user-serviceable parts.
11. STORAGE INSTRUCTIONS
1.
Charge battery to full capacity before storage.
2.
Store this unit at temperatures between
-
4°F-
+
140°F
(
-
20°C-
+
60°C).
3.
Never completely discharge the battery.
4.
Charge after each use.
5.
Charge at least once every month, if not in frequent use, to
prevent over-discharge.
To Next Page
Loading...