Page 9
6. SPECIFICATIONS
Internal battery type .......................... Lithium ion polymer
Capacity .............................................................. 41.44 Wh
USB output .....................................................5V DC, 2.4A
Quick Charge 3.0: 5V, 3A / 9V, 2A / 12V, 1.5A
Jump start ................................ 800A peak/400A cranking
Charging Temperature........................32
°
-122
°
F (0
°
-50
°
C)
7. REPLACEMENT PARTS
Battery clamps/smart cable............................ 94500889Z
Micro USB-USB charging cable ................. 3899003781Z
8. CHARGING THE JUMP STARTER
IMPORTANT! CHARGE IMMEDIATELY AFTER PURCHASE,
AFTER EACH USE AND EVERY 30 DAYS, OR WHEN THE
CHARGE LEVEL FALLS BELOW 85%, TO KEEP THE INTERNAL
BATTERY FULLY CHARGED AND PROLONG BATTERY LIFE.
CHECKING THE LEVEL OF THE INTERNAL BATTERY
1.
Slide the ON/OFF switch to the ON position. The LCD display
will show the battery’s percentage of charge. A fully charged
internal battery will read 100%. Charge the internal battery if
the display shows it is under 85%.
2.
To reduce the risk of electric shock, unplug the unit’s charging
cable from a USB or wall charger before attempting any main-
tenance or cleaning. Simply turning off the controls will not
reduce this risk.
3.
When charging the internal battery, work in a well ventilated
area and do not restrict the ventilation in any way.
CHARGING THE INTERNAL BATTERY
NOTE: Use a 2A USB charger (sold separately), or a 2A USB
charging port to quickly recharge the jump starter. Using a charger
with less than 2A will increase charge time.
1.
Plug the Micro USB end of the charging cable into the input
port. Next, plug the USB end of the charging cable into a
charger’s USB port.
2.
Plug your charger into a live AC or DC power outlet.
3.
The LCD display will light, the digit begins to flash and show
“IN”, indicating that charging has begun.
4.
The jump starter will fully charge in 4-5 hours. When the unit
is fully charged, the display will show “100%”.
To Next Page
Loading...