Menards MasterForce MFX2U2000

Questions and Answers

T
Thomas SimpsonAug 7, 2025
What to do if Menards MasterForce MFX2U2000 turns on for 2 seconds, shuts off, and won't turn back on?
- B
  Brenda WellsAug 7, 2025
  When the water is connected, the accessories are assembled properly, and the power is turned on, the Menards pressure washer may turn on for 1 - 2 seconds to prime the pump. It automatically shuts off and waits for the spray gun trigger to be pressed. When the trigger is pressed, water starts flowing through the pump. The water sensor in the pump “senses” the moving water and automatically turns the pressure washer on. You can also try turning the power off, holding in the trigger on the spray gun so that you have a steady stream of water. While you are holding the trigger open on the spray gun, at the same time, turn the power on.
R
Richard SmithAug 14, 2025
How to fix a Menards MasterForce MFX2U2000 that will not turn on?
- M
  martinstacyAug 14, 2025
  If your Menards pressure washer unit won't turn on, ensure the pressure washer is OFF. Plug the electrical cord into a grounded 120 volt outlet, avoiding extension cords. If the cord doesn't fit, the outlet may not be properly grounded; use a different outlet. If the issue persists, try another outlet. If it still doesn't work, contact Customer Service at 1-866-235-5112.
T
Tracy WilliamsAug 21, 2025
Why is water leaking where the high pressure hose connects to the spray gun on my Menards Pressure Washer?
- T
  Tiffany ClarkAug 21, 2025
  If water is leaking where the high pressure hose connects to the spray gun of your Menards Pressure Washer, make sure there is an o-ring at the end of the metal tip of the high pressure hose. If no o-ring is present, the connection between the hose and spray gun will leak. An O-Ring Replacement Kit (D) is included with purchase. Additional O-Ring Kits are available online at www. arblueclean.com or by calling Customer Service at 1-866-235-5112 to place an order.
E
eric16Aug 29, 2025
What to do if my Menards Pressure Washer is running but there is no water flow?
- M
  Megan LopezAug 29, 2025
  If there is no water flow when the unit is running on your Menards pressure washer, remember that power should NOT be turned on until water comes through the spray gun, as doing so will damage the motor. You should also check the water source, eject the nozzle from the lance to determine if clog is coming from the nozzle (If nozzle is clogged, see nozzle cleaning instructions under “Cleaning nozzles”), take off the lance and just spray out of the spray gun to indicate if the problem is with the lance, and check the Garden Hose Adapter for loose connection and the filter for debris.