Page 15
TROUBLESHOOTING
PROBLEM CORRECTIVE ACTION
Unit will not turn
on.
1. Make sure the pressure washer is OFF. Plug in the electrical cord to a
grounded 120 volt outlet (no electrical extension cord should be used).
If the electrical cord will not plug into your outlet, your electrical outlet is
not properly grounded and should not be used. Use another electrical
outlet.
2. If this did not correct the problem, try plugging into another electrical
outlet and repeat the above procedure. If it is still not working, call
Customer Service. 1-866-235-5112
The unit is running
but there is no
water flow.
1. Power should NOT be turned on until water comes through the spray
gun. Doing so will damage the motor.
2. Check the water source.
3. Eject the nozzle from the lance to determine if clog is coming from the
nozzle (If nozzle is clogged, see nozzle cleaning instructions under
“Cleaning nozzles”).
4. Take off the lance and just spray out of the spray gun. This will indicate
if the problem is with the lance.
5. Check Garden Hose Adapter for loose connection and the filter for
debris.
Why is water
leaking where the
high pressure hose
connects to the
spray gun?
1. Make sure there is an o-ring at the end of the metal tip of the high
pressure hose. If no o-ring is present, the connection between the
hose and spray gun will leak. O-Ring Replacement Kit (D) is included
with purchase. Additional O-Ring Kits are available online at www.
arblueclean.com or call Customer Service at 1-866-235-5112 to place
an order.
The pressure
washer turns on for
2 seconds, shuts
off, and will not
turn back on. Do
I have a defective
unit?
1. When the water is connected, the accessories are assembled properly,
and the power is turned on, the pressure washer may turn on for 1 - 2
seconds to prime the pump. It automatically shuts off and waits for the
spray gun trigger to be pressed. When the trigger is pressed, water
starts flowing through the pump. The water sensor in the pump “senses”
the moving water and automatically turns the pressure washer on.
2. Turn the power off, hold in the trigger on the spray gun so that you have
a steady stream of water. While you are holding the trigger open on the
spray gun, at the same time, turn the power on.
If you have any questions regarding the product, please call customer service at 1-866-235-5112
96046_IM_MFX2U2000.indd 1596046_IM_MFX2U2000.indd 15 2020/12/10 上午10:382020/12/10 上午10:38
To Next Page
Loading...
