EasyManua.ls Logo

Menumaster CFSP70 - Electrical Requirements; Grounding Instructions; Microwave Power; Installation

Default Icon
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5
Electrical Requirements
GROUNDING INSTRUCTIONS
Installation
Unpacking Oven
Inspect microwave oven for damage such as
dents in door or dents inside oven cavity.
Report any dents or breakage to source of
purchase immediately. Do not attempt to
use oven if damaged.
Remove all materials from oven interior.
If oven has been stored in extremely cold
area, wait a few hours before plugging in.
DO NOT UNDER ANY
CIRCUMSTANCES CUT OR
REMOVE THE ROUND
GROUNDING PRONG FROM
THE PLUG OR BEND THE
POWER PRONGS TO FIT A
RECEPTACLE OTHER THAN
THE ONE SHOWN FOR YOUR
OVEN. SUCH ABUSE OF THE
PLUG CAN RESULT IN
ELECTRICAL SHOCKS OR
OVERHEATING.
120V-15AMP
Microwave Power
Models CFSP70, GSAND-7D, SAND-7D and SAND-700 deliver 750 watts of cooking power to the
oven cavity.
Oven Placement
Do not install microwave oven next to or above
source of heat, such as pizza oven or deep fat
fryer.This could cause microwave oven to
operate improperly and could shorten life of
electrical parts.
Allow air flow around unit. Air flows around
electric components. At least one inch of clearance
is required at top and sides of unit to provide
proper ventilation. With restricted air flow unit will
not operate properly and life of electrical parts will
shorten.
WARNING - IMPROPER USE OF THE GROUNDING
PLUG CAN RESULT IN A RISK OF ELECTRIC SHOCK OR
DEATH.
This appliance MUST be grounded. In the event of an electrical
short circuit, grounding reduces the risk of electric shock by
providing an escape wire for the electric current. This appliance
is equipped with a cord having a grounding wire with a grounding
plug. The plug must be plugged into an outlet that is properly
installed and grounded. DO NOT use a two-prong adapter.
Consult a qualified electrician or serviceman if the grounding
instructions are not completely understood, or if doubt exists as
to whether the appliance is properly grounded.
Do not use an extension cord. If the product power cord is too
short, have a qualified electrician install a three-slot receptacle.
This oven should be plugged into a separate 60 hertz circuit with
the electrical rating as shown in the appropriate drawing at left.
When a microwave oven is on a circuit with other appliances, an
increase in cooking times may be required and fuses can be
blown.

Related product manuals