Menzer ETS 150 5.0 - Page 26

6 EN
ENGLISH
• Immediatelydisconnectthemachinefrom
mainselectricitywhentakingabreakornishing
work for the day.
• Makesuretokeepthepowercableofthe
power tool at a safe distance from the driving
disc to further reduce the risk of electrocution.
That will minimise the risk of damage to the
cable insulation or cutting through the cable with
the abrasive and also prevent the cable looping
around your hand or arm.
• Unplugthemainsplugimmediatelyiftheelec-
tric cable is damaged.
• Donotpulltheelectriccablearoundcorners,
as this might result in kinks or tears in the cable,
which could then cause additional damage at a
later time.
• Neverpullontheelectriccableandonlyusethe
actual plug to unplug the electric power tool. Do
not suspend the power tool by its power cable.
• Switchothemachinebeforereplacingthe
sanding disc, polishing disc or the polishing pad.
• Disconnectthemachinefrommainspower
before replacing the driving disc.
• Donotexposeanypartofthepowertoolto
caustic media (e.g. chemicals) or excessive heat
(above60°C).
• Donotattempttomaketechnicalchangesto
the power tool.
• Keeptheelectricpowertoolawayfromrainand
moisture.
• UseonlyMENZER-recommendedabrasivesand
driving discs compliant with the intended use
and the power tool dimensions. All accessories
musttthedriveshaftexactlytopreventuneven
running, vibration and loss of control over the
power tool.
• Deterioratingadherenceofthehook&loop
layer on the driving disc may cause accessory
parts for the driving disc (e.g. sanding discs)
to detach and cause injuries. This may occur
specicallyduringnon-contactoperation.The
driving disc must therefore be replaced, once
adherence deteriorates.
• Onlyusesandingdiscsofthecorrect
size and in compliance with manufacturer
recommendations.
• Donotattemptworkingwithusedorwornand
adapted sanding discs from larger electric power
tools.
•Afterafallofthepowertool,checktheelectric
power tool and the driving disc for visible
damage. Remove the driving disc for thorough
inspection.
Contact your MENZER Service workshop for
repairs of any damaged parts before use.
A broken driving disc and damaged machines
may cause injuries or negatively impact the
handling of the power tools.
• Theuseofdamagedaccessoriesisprohibited.
All accessories and the driving disc must be
checked and replaced as needed before every
use and after a fall or other potentially damaging
occurrence.
• Donotuseaccessorieswitharotationalspeed
that does not match or is lower than the max. ro-
tational speed stated on the electric power tool.
• Onlyusetherandomorbitalsanderondry
substrates.Donotusewateroranyliquidcool-
ing lubricants, as these could facilitate poten-
tially fatal electric shocks.
• Donotoperatethemachinedirectlynextto
or very close to your body to prevent cuts or
more serious injuries. The electric power tool
must only be carried on the body when it is at a
complete standstill.
• Putdownthemachineonlyafteritwas
switchedoandthedrivingdischascometoa
complete standstill to prevent hooking or recoil.
• Neverputdownthemachineontopofits
operating lever.
• Regularlycleantheventilationslitsonthema-
chine to maintain proper cooling and to prevent
electrically conductive dust deposits, as these
pose an electrocution or short circuit hazard.
Disconnect the machine from mains electricity
and use compressed air to clean the ventilation
slits.