Menzer ETS 150 5.0 - Working environment

EN 7
ENGLISH
• Switchothepowertoolimmediatelyifit
produces unusual noises or if you feel unusual
vibration; make sure to contact MENZER Service
immediately.
• Machineoperationmaygeneratehazardous/
toxicdusts(e.g.whensandingspecictypes
of wood or mineral substances). Inhaling or
skin contact with these types of dust may be
hazardous for the machine operator and any
other person within the work area.
Takenoteofthesafetyrequirementsapplicable
in your country.
Connect the power tool to an appropriate dust
extraction system.
• Thefollowingsafetymeasuresmustbead-
hered to when sanding mixed dusts with metal
content(e.g.lacquerprocessingintheautomo-
tive sector). The same applies if sanding in a
moist environment is unavoidable:
–Upstreamintegrationofafaultcurrent(FI,
PRCD)
circuit breaker.
– Connection of an appropriate dust extractor to
the machine.
– Regular use of compressed air to clean the
motor
housing interior of dust deposits.
• Takeextracarewhenworkingincorners,along
sharp edges, etc. (see also chapter 4.4)
• Preventsharpimpactsandentanglementsof
the accessory parts on the workpiece. (see also
chapter 4.4)
• WearaP2respiratorymasktoprotectyour
health.
• Alwayswearprotectivegogglestoprotectyour
eyes while sanding.
• Caution!Firehazard!Cleanoil-soakedwork
materials (e.g. sanding pads or polishing felt
pads)withwaterandsetthemoutattodry.Oil-
soaked work materials can spontaneously ignite.
• Caution!Firehazard!Avoidoverheatingofthe
workpiece and the sander. Always empty the
dust collection container before taking a work
break.Sandingdustinthelterbagorlterof
the dust extractor can spontaneously ignite
inunfavourableconditions.Therehazard
increases if the sanding dust mixes with varnish
or polyurethane residues or other chemical
components and the workpiece heats up after an
extended work session.
• Keepthegripsandgripareasdry,cleanand
free from oil or grease.
4.3 Working environment
• Ensurethattherearenootherpersonsatyour
workplaceorthatthereisasucientsafetydis-
tance between you and the next person.
• Anynails,boltsorothermetalobjectsmustbe
removed from or fully countersunk into the work
surface to prevent damage to the driving disc. This
measure will help prevent power tool damage,
jamming and recoil.
• Attachanappropriateindustrialdustextractor
to reduce the dust load.
• Workingwithelectricpowertoolscannegatively
impact your hearing. Wear hearing protection!
• Sandingdustandyingfragmentsfromthe
abrasive or the workpiece are a hazard for your
eyesight. Wear protective goggles!
• Sandingdustposesahazardtoairwaysand
lungs. Wear a protective mask (e.g. a P2 respira-
tory mask)!
• Keepyourhands,hair,feetandloose-tting
clothing away from the driving disc and/or ad-
ditionally protect these.
• Avoidphysicalcontactwithgroundedsurfaces
like radiators or pipes, cookers and refrigerators.
• Wearnon-skidworkboots.
• Ensuresecurefooting(goodgroundcontactand
balance) and avoid working too far overhead, as
you might lose your balance.