Menzer ETS 150 5.0 - Error handling and troubleshooting

12 E N
ENGLISH
Problem possible causes remediation
• Themachineis
without function or
malfunctioning.
• Mainsplugisincorrectlyinserted
into the mains socket.
• Mainsplugisdefective.
• Mainsfusewastripped.
• Checktheplugconnection;insert
the mains plug correctly into the
mains socket.
•Checkthemainsfuse.
• ContacttheMENZERrepairservice.
• Themachineis
too noisy.
• Machinevibration
is excessive.
• Thedrivingdiscorabrasiveisnot
attached correctly.
• Thematerialorsubstratetobe
processed is too hard.
• Attachthedrivingdiscandabrasive
securely and centrically.
• Changetherotationalspeed.
• Chooseanotherabrasive. Read our
abrasive overviews or seek advice.
• ContacttheMENZERrepairservice.
• Themachine
produces too much
dust.
• Insucient
extraction perfor-
mance.
• Cloggedextractionsystem.
• Dustbagintheindustrialextractor
is full.
• Kinkintheextractorhose.
• Theextractionopeningsinthe
driving disc and sanding disc are not
congruent.
• Cleantheextractionsystem.
• Emptythedustbag.
• Removethekink.
• Positiontheextractionopenings
congruently.
• Toomuchof
the substrate is
abraded.
• Thegritsizeoftheabrasiveistoo
large.
• Chooseasmallergritsize.
• Theentiresand-
ing area displays a
bad or sub-optimal
surfacequality.
• Theabrasivegritisincorrectortoo
large and/or the incorrect type of
abrasive is being used.
• Thematerialorsubstratetobepro-
cessed is not yet completely dry.
• Thematerialorsubstratetobe
processed is too soft and/or has a very
highllercontent.
• Chooseasmallergritsizeand/ora
dierenttypeofabrasive. Read our
abrasive overviews or seek advice.
• Readthedatasheetsandprocessing
instructions provided by the manufac-
turer of the material to be processed.
• Striaeinthe
sanded area.
• Drivingdiscnotatonthesubstrate.
• Thematerialorsubstratetobe
processed is too soft.
• Positionthedrivingdiscatonthe
substrate.
• Chooseasmallergritsize.
• Deteriorating
adhesion of
the abrasive or
the driving disc
accessory.
• Reverseoftheabrasiveisworn.
• Hook&looplayeronthedrivingdisc
is worn.
• Replacetheabrasive.
• Replacethedrivingdisc.
•UseMENZERpadsaver.
7. Error handling and troubleshooting