Securing the child restraint system
Adjusting the seat correctly
When tting a child restraint system on the le or
right rear seat, always observe the following:
#
Make sure that the child's feet do not touch
the front seat. If necessary, move the front
seat slightly forwards.
If the head restraint of the child restraint system
cannot be fully extended when it is installed in the
vehicle, this will result in restrictions on the maxi-
mum size setting for certain child restraint sys-
tems. Observe the child restraint system manu-
facturer's installation instructions.
%
Contact with the roof when the head restraint
is fully extended and locked in place will not
result in any restrictions on use.
®° When tting an ISOFIX/LATCH or
i‑Size child restraint system, also observe the fol-
lowing:
#
When using a rearward-facing child restraint
system on a rear seat: adjust the front seat so
that it does not touch the child restraint sys-
tem.
#
When using a forward-facing child restraint
system with integrated child seat belt: adjust
the head restraint of the respective seat so
that it does not push the child restraint system
forwards. If necessary, the respective head
restraint can be removed. In addition, the
backrest of the child restraint system must lie
as at as possible against the backrest of the
vehicle seat. Aer the child restraint system
has been removed, replace the vehicle head
restraint immediately and adjust correctly.
#
The child restraint system must not be put
under strain between the roof and the seat
cushion and/or be tted facing the wrong
direction. Where possible, adjust the seat
cushion inclination accordingly.
#
Adjust the vehicle head restraints so that the
child restraint system is not put under strain
by the head restraint.
7 When tting a belt-secured child restraint
system, also observe the following:
#
When using a rearward-facing child restraint
system on a rear seat: adjust the front seat so
that it does not touch the child restraint sys-
tem.
#
When using a forward-facing child restraint
system with integrated child seat belt: adjust
the head restraint of the respective seat so
that it does not push the child restraint system
forwards. If necessary, the respective head
restraint can be removed. In addition, the
backrest of the child restraint system must lie
as at as possible against the backrest of the
vehicle seat. Aer the child restraint system
has been removed, replace the vehicle head
restraint immediately and adjust correctly.
#
The backrest of the forward-facing child
restraint system must, as far as possible, be
resting on the seat backrest of the rear seat.
#
The child restraint system must not be put
under strain between the roof and the seat
cushion and/or be tted facing the wrong
136
Children in the vehicle – Securing the child restraint system
F297 0017 02
To Next Page
Loading...
Need help?
General
