EasyManua.ls Logo

MerCruiser Black Scorpion - User Manual

MerCruiser Black Scorpion
106 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
© 2007 Mercury Marine Black Scorpion and MX 6.2 Black Scorpion MPI Tow Sports Models 90-865253070 607
NOTE: The following applies to CE marked products only.
Declaration of Conformance – Mercury MerCruiser
This sterndrive or inboard engine when installed in accordance to Mercury
MerCruisers’ instructions complies with the requirements of the following directives
by meeting the associated standards, as amended:
Recreational Craft Directive 94/25/EC; 2003/44/EC
Applicable Requirement Standards Applied
Owner’s manual (A.2.5) ISO 10240
Openings in Hull, Deck and superstructure (A.3.4) ISO 9093‑1; ISO 9093‑2
Handling characteristics (A.4) ISO 8665
Inboard Engine (A.5.1.1) ISO 15584; ISO 10088; ISO 7840; ISO 10133
Fuel System (A.5.2) ISO 10088; ISO 7840; ISO 8469
Electrical System (A.5.3) ISO 10133; ISO 8846
Steering system (A.5.4)
Applicable portions of: ISO 10592, ISO 8848 and
ABYC P‑17
Exhaust emission requirements (B.2) ISO 8178
Owner’s manual (B.4) ISO 8665
Noise emission levels (C.1) ISO 14509
Ignition‑protected equipment (Annex II) ISO 8846; SAE J1171; SAE J1191; SAE J 2031
Mercury MerCruiser declares that our sterndrive or inboard engines without integral
exhaust, when installed in a recreational craft, in accordance with the manufacturers
supplied instructions, will meet the exhaust emissions requirements of the directive
mentioned above. This engine must not be put into service until the recreational craft
in which it is to be installed has been declared in conformity, if so required, with the
relevant provision of the directive.
Electromagnetic Compatibility Directive 89/336/EC, 92/31/EEC and 93/68/EEC
Generic emission standard EN 50081‑1
Generic immunity standard EN 50082‑1
Vehicles, boats and internal combustion engine
driven devices ‑ Radio disturbance characteristics
SAE J551 (CISPR 12)
Electrostatic discharge testing EN 61000‑6‑2; EN 61000‑4‑2; EN61000‑4‑3
The notified body responsible for surveillance of the quality system under Full Quality Assurance
Module H of Directive 2003/44/EC is:
Det Norske Veritas
Norway
Notified Body Number: 0575
This declaration is issued under the sole responsibility of Mercury Marine and Mercury MerCruiser.
Patrick C. Mackey
President ‑ Mercury Marine, Fond du Lac, WI USA

Table of Contents

Questions and Answers

  • T
    Tracy ClarkAug 18, 2025
    What to do if there is insufficient oil in the crankcase of my MerCruiser Engine?
    • R
      raymond06Aug 18, 2025
      If there is insufficient oil in the crankcase, check the oil level and add oil as needed.
  • S
    Steve JenningsAug 20, 2025
    What to do if the drive belt on my MerCruiser Black Scorpion is loose or in poor condition?
    • K
      knealAug 20, 2025
      If the drive belt is loose or in poor condition, replace or adjust the belt.
  • T
    Taylor ClarkAug 23, 2025
    What to do if the seawater pickups or sea strainer on my MerCruiser Black Scorpion are obstructed?
    • R
      robertsmicheleAug 23, 2025
      If the seawater pickups or sea strainer are obstructed, remove the obstruction.
  • D
    Dan FitzgeraldAug 26, 2025
    What to do if the boat bottom of my MerCruiser Black Scorpion is fouled or damaged?
    • E
      Elizabeth PatelAug 26, 2025
      If the boat bottom is fouled or damaged, clean or repair it as necessary.
  • D
    David SparksAug 28, 2025
    What to do if the propeller of my MerCruiser Engine is damaged or improper?
    • J
      Jason JenkinsAug 28, 2025
      If the propeller is damaged or improper, replace it.
  • P
    pbergerAug 30, 2025
    What to do if the seawater discharge of my MerCruiser Black Scorpion Engine is restricted or plugged?
    • K
      Kerri HowellAug 30, 2025
      If the seawater discharge is restricted or plugged, clean the exhaust elbows.
  • J
    Judith LopezSep 2, 2025
    What to do if my boat with MerCruiser Black Scorpion is overloaded or the load is improperly distributed?
    • B
      brianwrightSep 2, 2025
      If the boat is overloaded or the load is improperly distributed, reduce the load or redistribute the load more evenly.
  • D
    daniellebrownSep 4, 2025
    What to do if the coolant level is low in the closed cooling section of my MerCruiser Black Scorpion Engine?
    • D
      debbie21Sep 4, 2025
      If the coolant level is low in the closed cooling section, check for the cause of the low coolant level and repair. Fill the system with the proper coolant solution.
  • E
    Erika PhillipsSep 6, 2025
    What to do if the Heat Exchanger or Fluid Cooler of my MerCruiser Black Scorpion is plugged with foreign material?
    • B
      Brian MatthewsSep 7, 2025
      Clean the Heat Exchanger, Engine Oil Cooler, and Transmission Oil Cooler (if equipped) if they are plugged with foreign material.
  • K
    Kristen CurtisSep 9, 2025
    What to do if there is excessive bilge water in my boat with MerCruiser Black Scorpion?
    • S
      Stephen WolfSep 9, 2025
      If there's excessive bilge water, drain and check for the cause of entry.

MerCruiser Black Scorpion Specifications

General IconGeneral
Engine TypeV8
IgnitionElectronic
Alternator65 amp
Fuel SystemMulti-port fuel injection
Cooling SystemClosed cooling
RotationStandard

Related product manuals