STORAGE
SECTION 6
CMD-3967823 / 90-865237030 OCTOBER 2003 Page 99
10. Perform all checks on the Operation Chart in the Starting Procedure column. Refer to
Section 3.
CAUTION
Overheating from insufficient cooling water will cause engine and drive system
damage. Ensure that there is sufficient water always available at water inlet
openings during operation.
11. Supply cooling water to the water inlet openings.
IMPORTANT: Avoid overheating the starter in the following step. Do not engage the
starter motor for more than 15 seconds. Allow at least one minute cool down time
before engaging the starter for another 15 seconds.
12. After having not been operated for 2 months or longer, it is necessary to pre-lubricate
the turbocharger and engine.
a. Hold the STOP switch engaged while you simultaneously turn the key switch to the
START position for 15 seconds. Doing this together turns the engine without starting
it.
b. Repeat step a. as needed. Pre-lubrication is complete when oil pressure is shown
by the instruments.
13. Start the engine and closely observe instrumentation. Ensure that all systems are
functioning correctly.
14. Carefully inspect the engine for fuel, oil, fluid, water and exhaust leaks.
15. Inspect the steering system, shift and throttle control for proper operation.
To Next Page
Loading...
Need help?
General