Mercury 115 HP - Page 14

2. Use a 15 mm socket to loosen the clamp nut so it is almost completely off.
a - Rubber boot
b - Clamp nut
3. Loosen the 6 mm Allen socket head screw.
a - 6 mm Allen socket head
screw
4. Lift the clamp and rotate the tiller handle to the desired angle.
5. Tighten the clamp nut to the specified torque and install the rubber boot.
a - Clamp
b - Clamp nut
Description Nm lb‑in. lb‑ft
Clamp nut 50 – 36.9
6. Tighten the 6 mm Allen socket head screw to the specified torque.
Description
Nm lb‑in. lb‑ft
6 mm Allen socket head screw 24.4 – 18
a
b
69167
a
69168
a
b
69481
ADJUSTMENTS
8 eng