STORAGE
52
IMPORTANT: Refer to
Spark Plug Inspection and Replacement
for correct procedure for removing spark plug
leads.
1. Remove the spark plugs and add approximately 30 ml (1 oz.) of engine oil into each spark plug hole.
2. Rotate the flywheel manually several times to distribute the oil in the cylinders.
3. Re‑install spark plugs.
Protecting External Outboard Components
• Lubricate all outboard components listed in Maintenance ‑ Inspection and Maintenance Schedule.
• Touch up any paint nicks. See your dealer for touch‑up paint.
• Spray Quicksilver or Mercury Precision Lubricants Corrosion Guard on external metal surfaces (except
corrosion control anodes).
Tube Ref No. Description Where Used Part No.
120
Corrosion Guard External metal surfaces
92-802878Q5
5
Gearcase
• Drain and refill the gearcase lubricant (refer to Maintenance ‑ Gearcase Lubrication).
Positioning Outboard For Storage
Store outboard in an upright (vertical) position to allow water to drain out of outboard.
!
CAUTION
If outboard is stored tilted up in freezing temperature, trapped cooling water or rain water that may have entered
the propeller exhaust outlet in the gearcase could freeze and cause damage to the outboard.
Battery Storage
• Follow the battery manufacturer's instructions for storage and recharging.
• Remove the battery from the boat and check water level. Recharge if necessary.
• Store the battery in a cool, dry place.
• Periodically check the water level and recharge the battery during storage.
To Next Page
Loading...
Need help?
General
