TILTING THE OUTBOARD TO FULL UP POSITION
To tilt the outboard, shut off the engine and press the tilt switch to the up
position. The outboard will tilt up until the switch is released or it reaches its
maximum tilt position.
1. Engage the tilt support lever by rotating the lever down.
2. Lower the outboard to rest on the tilt support lever.
3. Disengage the tilt support lever by slightly tilting up the outboard and
releasing the tilt support bracket. Lower the outboard.
a - Tilt support lever
PROKICKER CENTERING STRAPS FEATURE
ProKicker centering straps (if equipped) will center the outboard and prevent
the outboard from turning while the outboard is tilted up.
The ProKicker centering straps will prevent the outboard from turning when
tilted up. If using a steering tie bar to a second outboard, disconnect the
steering tie bar to allow steering of the second outboard.
!
WARNING
Avoid injury or death from loss of steering control. ProKicker centering straps
prevent the outboard from turning when tilted up. If using a steering tie bar to
a second outboard, disconnect the steering tie bar to allow steering of the
second outboard before operating the boat.
a - ProKicker centering straps
To Next Page
Loading...
