GENERAL INFORMATION
90-827242R02 FEBRUARY 2003 Page 1C-11
Decal Application
Decal Removal
1. Mark decal location before removal to assure proper alignment of new decal.
2. Carefully soften decal and decal adhesive with a heat gun or heat blower while removing
old decal.
3. Clean decal contact area with a 1:1 mixture of isopropyl alcohol and water.
4. Thoroughly dry decal contact area and check for a completely cleaned surface.
Instructions for Wet Application
NOTE: The following decal installation instructions are provided for a wet installation. All
decals should be applied wet.
TOOLS REQUIRED
1. Plastic Squeegee*
2. Stick Pin
3. Dish Washing liquid detergent without ammonia. Do not use a soap that contains
petroleum based solvents.
** Automotive body filler squeegee.
SERVICE TIP: Placement of decals using the wet application will allow time to
position decal. Read entire installation instructions on this technique before
proceeding.
TEMPERATURE
IMPORTANT: Installation of vinyl decals should not be attempted while in direct
sunlight. Air and surface temperature should be between 15°C (60°F) and 38°C
(100°F) for best application.
SURFACE PREPARATION
IMPORTANT: Do not use a soap or any petroleum based solvents to clean application
surface.
Clean entire application surface with mild dish washing liquid and water. Rinse surface
thoroughly with clean water.
To Next Page
Loading...
